Kong Rengjørings-og Beskyttelsesolje, Yellow, 50ml

Fordeler

• PTFE (Teflon) additive reduces friction and wear on small pivots, hinges, and axles.
• Low viscosity (3.5 cSt @ 40 °C) penetrates tight tolerances found in carabiner gates and pulley bearings.
• Water-insoluble base oil provides basic corrosion protection on steel and aluminum hardware.
• Very low vapor pressure (<0.1 kPa @ 20 °C) limits evaporation during storage/use.
• Suitable for targeted maintenance of carabiners, pulleys, and cam/lever pivots when applied sparingly.

Ting å vurdere

• Oil-based PTFE lubricant can attract dust and grit; requires careful wipe-down and is suboptimal in sandy/dusty environments compared to dry lubes.
• Must be kept off ropes, webbing, braking/friction surfaces, and toothed cam faces; contamination can reduce friction/braking performance.
• Flammable (flash point 82 °C, PMCC); requires cautious storage and use away from ignition sources.
• No published low-temperature/pour-point spec; potential thickening and reduced flow in sub-zero conditions.
• Not biodegradable; potential environmental concerns for outdoor use if over-applied or spilled.

Oppsummering & anbefalinger

A light PTFE oil formulated for maintaining moving metal parts on climbing equipment. Its low viscosity and PTFE content suit hinges and axles, and it offers basic corrosion protection. As with similar oils, it can attract debris and must be kept away from textiles and friction surfaces. Best for controlled, post-cleaning maintenance of carabiners, pulleys, and pivoting mechanisms; less suitable in gritty conditions or where rope contamination risk exists.

Bruksområder & tips

Intended for precision lubrication and protection of metal moving parts on climbing hardware (e.g., carabiner gate/pin, pulley axles, cam/lever pivots). Apply sparingly, then wipe excess. Do not use on ropes, slings, belay/rappel friction paths, braking surfaces, or toothed cam contact areas. Prefer dry lubes or graphite in dusty/sandy environments.